RF Radio DATA transmmiter and reciever

-

Comments

Post a Comment

Popular posts from this blog

LEDs control using nodemcu and ir remote.

-
(Code for the project.)  #include <IRrecv.h> #define BLYNK_PRINT Serial #include <ESP8266WiFi.h> #include <BlynkSimpleEsp8266.h> uint16_t RECV_PIN = D5; IRrecv irrecv(RECV_PIN); decode_results results; int LED1 = D0;  int LED2 = D1;  int LED3 = D2;  int LED4 = D3;  int LED5 = D4;  int LED6 = D5;    int swval[] = {0,0,0,0,0,0,0}; char auth[] = "auth token"; // Your WiFi credentials. // Set password to "" for open networks. char ssid[] = "ssidname"; char pass[] = "paswward"; void setup() {  Serial.begin(9600);   Blynk.begin(auth, ssid, pass);     irrecv.enableIRIn();  // Start the receiver   pinMode(LED1, OUTPUT);   pinMode(LED2, OUTPUT);   pinMode(LED3, OUTPUT);   pinMode(LED4, OUTPUT);    pinMode(LED5, OUTPUT);   pinMode(LED6, OUTPUT);       digitalWrite(LED1, LOW);   digitalWrite(LED2, LOW);   digitalWrite(LED3, LOW);   digitalWrite(LED4, L...
Read more

IoT Based Voice Controlled Home Automation Using NodeMCU & Android.

-
Image
  ☝ This tutorial is all about  IoT Based Voice Controlled Home Automation Using NodeMCU & Android . Previously we have made similar types of  IoT based Home Automation Projects to control relay from NodeMCU web server . We have used  Asyncwebserver  to control home appliances from a web browser. But, today we will build our own Home Automation Android App using MIT App Inventor. Install it on Android smartphones and control our home appliances using  voice commands  as well as buttons. Table Of Contents Components Required Block Diagram of Voice Controlled Home Automation using ESP8266 Circuit: Wifi & Voice Controlled Home Automation Using ESP8266 Android App Voice Controlled Home Automation Creating an Android App Using MIT App Inventor: Home Automation App Download Link: Code to find NodeMCU IP Address Source Code/Program. This IoT based voice-controlled home automation project, allows you to interface 2/4/8 channel relay with NodeMCU ES...
Read more

NodeMCU Basic Project-Blink an built-in LED

-
Image
  In this lesson,we will introduce how to blink the on-board LED and how to blink a external LED. Hardware Preparation: NodeMCU x 1 LED x 1 200 ohm resistor x 1 Micro USB cable x 1   Software required: Software Arduino IDE(version 1.6.4+) Follow the below Steps In this part,we will learn how to use the Arduino IDE to blink the on-board LED,the blue led in the board was used to signal the execution of a particular procedure.Because the GPIO16 (DO) limitation to use the analogWrite() and looking to see my LED doing something else… First,connect the NodeMCU to the PC,put below code to the Arduino IDE: #define LED D0 // Led in NodeMCU at pin GPIO16 (D0). void setup() { pinMode(LED, OUTPUT); // LED pin as output. } void loop() { digitalWrite(LED, HIGH);// turn the LED off.(Note that LOW is the voltage level but actually //the LED is on; this is because it is acive low on the ESP8266. delay(1000); // wait for 1 second. digitalWrite(L...
Read more